| |
Our Mustang Street/Strip II motor mounts have just been
released! These are the same motor mounts used in our 900HP
Obsidian SG-One as well as our 350 HP
Phantom DSC-II. With our
adjustable motor mounts, you can now move your engine forward,
back, left, right and even up!* These motor mounts are perfect
for either the track or the street and are a must for difficult
header applications. Sometimes headers just don’t fit and you’ll
need to A) chop away at your new expensive headers, or B) move
your engine around with our motor mounts to get that little bit
of clearance you need. They’re stronger than the competition’s
and more adjustable. What else do you need?
- Precision water-jet manufactured
- Tig Welded for maximum strength
- Polyurethane bushing (see below)
- 5” of back/forth travel
- 1.5” of left/right travel
- Pre assembled for ease of installation
- No drilling required.
Price:
$249.95
Click here for PDF Instructions
*
In order to move engine up, you will need
a motor mount spacer. Spacers are available in different
increments upon request. Spacers sold separately.
|
Slotted top
bolt hole accommodates factory variances
on bolt holes.
|
Thick .445
Steel makes our motor mounts stronger
than the competition's at it's most
crucial point.
|
| |
Slots allow
for left or
right movement.
The "Thru" bolts
on each mount
must be loosened
for movement.
|
|
Urethane
bushing gives
more rigidity
which equals
less drive train
loss.
|
|
Long slot
allows for adequate back and
forth travel. "Thru" bolts
on each mount must be
loosened
for movement. More
adjustability can
be achieved by
swapping top plates from end
to end. |
|
|
|
|
