| |
This front splitter is one of the nicest available to accent the
front of the 2005+ Mustang GT, and it fits like a glove, using
stainless steel bolts and hardware from the underside for a
secure, long lasting install. Molded from thick fiberglass in
matt black it can be installed as is, or can be painted to match
after surface prep if desired. The piece clears most curbs and
bumps even on lowered Mustangs, and helps direct airflow better
over the front of the car, while filling in the gap under the
front radiator inlet.
Highway mileage may improve, but your results may vary. Comes
with instructions and all necessary installation hardware.
Installation re-uses 6 existing holes on the bottom of the
bumper cover, and six additional 1/4" holes will need to be
drilled to complete the installation. Weight shown is for
shipping purposes, actual weight of part is 8 lbs.
GT ONLY - does not fit V6, Shelby, GT/CS, ect.
|
|
