 |
 |
|
Factory steering box frame holes are used to
mount Left rack bracket and drag link holes are used for the right rack
brackets.
|
Left rack bracket installed. |
 |
 |
You must drill 2 holes through the outer
frame lip on both
left and right sides of the car, after brackets are installed. |
Install the reinforcement plate and bolts to
the outer frame lip.
|
 |
 |
|
You are now ready to install the rack into
the mounting brackets and tighten it all down.
|
View of Right side rack mounting bracket
with the RRS rack installed. |
 |
 |
|
View of Left rack mounting bracket with the
RRS rack installed
|
View of right bracket from wheel well.
|
 |
 |
|
Now connect both left and right outer tie
rod ends to the inner tie rods. When the car is on the ground you can do a rough
alignment. Remember take your car to get an wheel alignment
|
Install your column into your car using the original
dash brackets. Center the RRS rack, slide the shaft on the RRS rack spine.
Check and tighten all bolts, center your steering wheel. Check to make you
followed all the RRS install instructions supplied in the install book. |
 |
View of steering shaft looking
down into the engine compartment on left side.
|
|
These pictures we have
supplied and instructions are only to be used as a guide
so you know what to expect when you are installing your
new RRS rack system. |